Crossmember Assembly And Installation - Putting The Pieces Together
|
The towers for this kit are designed so the inside vertical edges (the part that looks like it might get welded to the frame--but doesn't) are to be 28 inches apart. The difference between the frame width and the 28 inches was 4 1/4 inches, which was then divided by 2. The towers were marked for 2 1/8-inch notches. Once the height of the notch was determined, Joe installed the upper control arm to check that there was clearance between it and the frame (stock control arms require a lot more clearance than tubular arms). View Related Article
|
|