Rod & Custom Homepage Rod & Custom

Twin Molded Side Pipes

Once the tubing was welded to the rocker panel, it required two bends at the bottom of the front fender to enable the pipes to appear to exit the bodywork. These bends were trimmed from a pair of 1 3/4-inch-diameter, 90-degree bends.
Twin Molded Side Pipes - A Bit On The Side

Once the tubing was welded to the rocker panel, it required two bends at the bottom of the front fender to enable the pipes to appear to exit the bodywork. These bends were trimmed from a pair of 1 3/4-inch-diameter, 90-degree bends.  View Related Article

 

Get Adobe Flash player